Usually, we make straight railings, so there are few problems.

However, many railing manufacturers are prone to make a mistake when customizing stainless steel stair guardrails, and the size they make does not conform to the size on site.

The reason is that at the beginning of measurement, the size of the concrete floor was pasted with ceramic tiles. When the size changed, the entire stair guardrail could not be installed.

However, if the customized guardrail is plated with color, it is difficult to change, which is a big problem.

It is recommended to measure the size of the stair railing when tiles are pasted. However, due to the progress of the project, most of them are on the cement floor.

Each step of the stairs shall be measured, because each step may be different.

During fabrication, space for change shall be reserved to pre lengthen the baluster and cut off the extra baluster on site. To accommodate errors.

Another problem is the level of large buildings.

When the length reaches tens of meters, the height of the same floor may vary by more than ten centimeters.

In this way, when the railings are installed, some positions are suspended, and the railings need to be pressed down hard, so the side looks not straight.

One way is to ask the mason and hydraulic workers to do a good job of leveling, and there is no difference in the height of the pasted ground.

One way is to adjust the length of the railing feet, and cut some column feet according to the ground. This method is only suitable for the ground with little difference.

To achieve the overall straightness, it needs to be done according to the height difference size of the site. If you wait until a problem occurs,

If the responsibility is put on the uneven ground of Party A, it will be a dispute.

The arc railings need to be molded and bent according to each arc in the factory. The cost of arc railing is higher, and the requirements of Party A are often high.